0 0,00 


No products in the cart.

The receiver and controller may occasionally go out of sync. To synchronize them, plug the receiver into your device and insert a thin pin (e.g. an unfolded paper clip) into the small hole on the side: you’ll feel a little “click” and, after a few seconds, the LED will start flashing rapidly.

Switch on the controller using the central button, but only release it when the LED strip is flashing rapidly.

After a few seconds, the LEDs on the controller and receiver stop flashing: they are now synchronized and you can use them as normal.

Leave a Reply

Your email address will not be published. Required fields are marked *